The reason why your Nissan mic can't be used is that the original is fed with 5 volt from your original head. It has a built in amplifier within the mic-housing. The Dasaita head does not support t...
The reason why your Nissan mic can't be used is that the original is fed with 5 volt from your original head. It has a built in amplifier within the mic-housing. The Dasaita head does not support t...
Have you tried the usual pull out and reseat the connector to the canbus-box? It's sometimes a little bit tricky get it in properly.
You started out in the wrong end. Sound, SWC and reverse has nothing to do with firmware. It's a canbus problem. Due to the fact that no car is selected, canbus won't work. Select your car to start...
You need to enable (I believe it's HD) in z-link setting.
José, He is talking about a SIM-card, not SD. Fransisco, there's no sim-card adapter available. Only Wifi, hotspot or modem.
Swap the two yellow camera connectors.
It will only activate automatically if you have an original Dasaita unit.
It looks like your canbus box do supply the reverse signal, but not video. You don't happen to have swapped the two yellow cam_in cables?
The MCU handles the reverse camera since the Android system is not started up yet. Do you have a Can-bus box? The canbus box normally handles the 360 camera and also supplies the reverse signal to...
My unit connects with or witout WPA2. Although the wifi-receiver is weak in the Max 10 unit or any similar unit. Why I'm talking about swapped connectors on Max 10 they are Wifi left GPS right. On ...
Some genius at Dasaita swapped Wifi and GPS connectors. Check that you're connected the right connector.
This is what you need. Nota bene this is for GPS so you need to modify the connector a tiny bit. https://www.amazon.com/StickyDeal-Antenna-Navigation-Satellite-Telematics/dp/B08JV1ZBFN/ref=sr_1_3?...
Still not worth the money to buy a new unit and find it to be the same unit as I already have. Instead, use their software launcher in your current Max10 and save the money.
Or just put update.zip on your USB-stick and the rest is all automatic.
You need to go to factory settings and change default SWK to canbus.
You need Zlink app. It handles Carplay and AA. Should already be installed.
You need to swap the two yellow Cam_Out cables.
@Tony Dunn One thing is, it should be right rudder since your car is rhd. For the rest, I don't know.
@Iker Gomez Well it doesn't say not finished, but under development in the ads from Dasaita. It actually says nothing. That's why I warned people not to buy it now. Wait for it to be at least mostl...
@Alan Austin Like my Max10 in less than one minute. Concerning your roof antenna. Sometimes there's an antenna amplifier which needs 12 volt. Could that be a part of your problem? In Max 10 it's th...